- Home
- DPA 5015A
Description
This is a complete surround kit with five carefully factory-matched d:dicate 4015 wide cardioid microphones. Even though the standard tolerances on the d:dicate 4015 wide cardioid microphones are extremely low, the surround match is even closer.
The specially selected d:dicate 4015 wide cardioid microphones are matched within +/-1dB on both frequency response and sensitivity from mean of set.
Recording orchestras or other acoustic ensembles sometimes requires a compromise between blending in the room reverberation and a more precise localization. The natural response and dynamic range make this surround kit an obvious choice for precise tone quality and wide dynamic range. This is a great solution for AB, Decca Tree or surround main arrays like our wide cardioid surround array.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory inlays.
Features:
- Wide pickup area and natural sound
- Five carefully matched microphones
- Ambience pickup with convenient directionality
- Peli Case transportation and protection
Specifications
- Directional pattern: wide cardioid
- Principle of operation: pressure gradient
- Cartridge type: pre-polarized condenser
- Frequency range: 20Hz to 20kHz
- Frequency range, +/-2dB: 40Hz to 20kHz
- Sensitivity, nominal, +/-2dB at 1kHz: 10mV/Pa, -40dB re. 1V/Pa
- Equivalent noise level, A-weighted: typ. 18dB(A) re. 20uPa (max. 20dB(A))
- Equivalent noise level, ITU-R BS.468-4: typ. 25dB (correct with the attenuator in 0dB or -20dB setting)
- S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 76dB(A)
- Total harmonic distortion (THD): <1% up to 139dB SPL peak
- Dynamic range: typ. 121dB
- Max. SPL, peak before clipping: 159dB
- Switchable attenuator, filters etc.: 0dB / -20dB
- Output impedance: 200Ohm
- Minimum load impedance: 2kOhm
- Cable drive capability: 100m
- Output balance principle: Impedance balancing with "Active Drive"
- Common mode rejection ratio (CMRR): >60dB
- Power supply (for full performance): 48V Phantom power (+/-4V)
- Current consumption: 2.8mA
- Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
- Color: matte black
- Weight: 158g
- Microphone/capsule diameter: 19/19mm
- Microphone length: 170mm
- Maximum output voltage, RMS: >5V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40°C to 45°C
- Relative humidity (RH): up to 90%
- Matching tolerance (frequency response and sensitivity): +/-1dB
- Phase deviation for kit: <10°
In the Box
Compare
Shopping cart
