ZAXCOM RX8

article code
zax.rx8
Zaxcom RX8 stand-alone receiver interface with integrated antenna distribution for 2x MRX214 / MRX414 receiver modules, 512-698 MHz
€ 3,084.29 Our Price € 2,549.00 Our Price

The RX-8 is an extremely small 8-channel receiver interface for your bag or cart. Accepting audio from up to 8 separate transmitters, the RX-8 contains a built-in MicPlexer with antenna distribution and front-end filter for eliminating interference from unwanted RF. It is the smallest 8-channel radio mic receiver system in the world! An optional Dante interface with Power over Ethernet (PoE) facilitates remote location and control.

RX-8 can output 8 channels of analog or AES digital audio at 0 dB line-level on the DB25 connector. The RS422 connector pairs with a TRXCL5 or IFB300 to share the ZaxNet remote control commands. It has two SMA RF loop throughs for additional antenna distribution.

The RX-8 receives up to eight channels of audio from eight separate transmitters when loaded with 2 x MRX414 slot-in receiver modules.

The RX-8 has a front-end filter, so you can receive on any frequency in any block from 20 through 26 (512-698MHz) with an impressive range. Here's how that works: the filter allows signals within the 35 MHz tunable window into the receiver while blocking the interfering high-level signals outside this window. We let the good stuff in (your radio mic transmitters) and we keep the bad stuff out (walkie-talkies, the follow focus, vampires, etc.). Think of it like the bouncer outside a nightclub.

The RX-8's built-in MicPlexer gives you an additional 3dB of RF amplification and antenna distribution for the two internal MRX slot-in receiver modules and additional receiver channels connected to the RF output connectors of the RX-8.

The MRX214 and MRX414 modules are hot-swappable and can be added or removed in any combination at any time, making the RX-8 highly flexible for when receiver requirements can change on a daily basis.

The RX-8 receives a 100% digital signal that is fully encrypted and is compatible with all Zaxcom modulations and transmitters.

Four OLED displays contain the menus for each receiver pair and tactile pushbuttons make receiver selection and toggling through menus a breeze. The built-in frequency scanner and Auto-Pick software eliminates the guesswork and can coordinate and choose the best frequencies with a push of a button.

The RX-8 is powered via a standard 12V Hirose connector.

The RX-8's built-in frequency scanner and Auto-Pick software can scan the RF spectrum and choose the best receiver frequencies. Using ZaxNet, when paired with an IFB300 or TRXCL5, the RX-8 can re-freq transmitters to match it with just the touch of a button. This combo also lets you make quick and easy transmitter gain adjustments. The groundbreaking RX-8 with Dante opens new frontiers of remote receiver control that has only been dreamt of in the past.

DB25 MRX I/O:

  • analog audio output: 8 channels balanced 0dB @ -20 dBFS
  • digital audio output: 8 channels (32 kHz Sample Rate)
  • audio connector: DB25 (wired to Tascam standard)

RECEIVER INTERFACE:

  • receiver slots: 2 (MRX Compatible)
  • RF input connectors: 2x SMA
  • RF output connectors: 2x SMA
  • RF impedance: 50 Ohm
  • RF sensitivity: -110 dB
  • RX decode: level 6 dB signal to noise in XR modulation
  • RF filter bandwidth: 35 MHz
  • RX-8 tuning range: 512-698 MHz
  • RF diversity single mode: true
  • RF diversity dual mode: antenna
  • antenna power: N/A

MRX414 MODULE:

  • receivers per module: 4
  • receiver modulation: Zaxcom proprietary digital
  • MRX414-L tuning range: 512-614 MHz
  • MRX414-M tuning range: 536-652 MHz
  • MRX414-H tuning range: 596-698 MHz
  • power consumption: 300 mA @ 12 VDC
  • size(L x W x H in mm): 127 x 76 x .203
  • weight: 198 g

MRX214 MODULE:

  • receivers per module: 2
  • receiver modulation: Zaxcom proprietary digital
  • MRX414-L tuning range: 512-614 MHz
  • MRX414-M tuning range: 536-652 MHz
  • MRX414-H tuning range: 596-698 MHz
  • power consumption: 160 mA @ 13 VDC
  • size(L x W x H in mm): 127 x 76 x .203
  • weight: 198 g

MISC:

  • power: 9 VDC to 18 VDC
  • power connector: Hirose HR10A-7P-4P
  • power consumption: 800mA
  • display: 4 x graphic OLED displays
  • RS422: 1 x USB
  • USB connector: future use
  • size (L x W X H in mm):216 x 203 x 25
  • weight: 1.1 kg with 2x MRX

More Information
BrandZaxcom
THERE ARE 2 OPTIONS AVAILABLE:
1. Pick-up your order at our store.
2. Choose one of the different options from our shipping partners, presented to you during check-out.