SCHOEPS CMC 1 U Desert Island Stereo Set with MK 5

article code
sch.134219
Schoeps CMC 1 U Desert Island Stereo Set with MK 5, incl. 2x CMC 1 U amplifier, 2x MK 5 matched omni/cardioid switchable with slight high frequency emphasis capsule, 2x SG20 clamp and Peli Case 1010 with insert
€ 3,995.42 Our Price € 3,302.00 Our Price

Schoeps now offers the best-selling modular microphone series Colette in as a matched set in a handy and robust Peli Case.

THIS SET INCLUDES:

  • 2x CMC 1 U microphone amplifiers
  • 2x MK 5 matched omni/cardioid capsules
  • 2x SG 20 stand clamps
  • Peli Case
  • certificate of matching for the capsules

CMC 1 U:

The CMC 1 is a small Colette microphone amplifier, about one-third the size and 40% lighter than the CMC 6. It is compatible with all components of the Colette system and can be used in place of the CMC 6 without compromise, for all applications in which the size and weight of the microphone play a role.

Uncompromising miniaturization means that the electrical characteristics of the CMC 1 are equal to, or even better than, those of the CMC 6. Through modern electronic design, these outstanding electrical properties have been achieved:

  • high maximum SPL: 135 dB-SPL with the MK 4 (0.5% THD or less)
  • very low current consumption: 2.0 mA at 48 Volts
  • operates on 48 V or 12 V phantom power, reliable operation even if powering is somewhat marginal
  • very high immunity from RF interference with the Schoeps RFI Shield, high immunity to cable-induced hum and other interference (field tested with Audio Limited A 10, etc.)
  • flat frequency response
  • very low distortion constant output impedance across the audio frequency range balanced, direct-coupled, class-A output circuit
  • output is filtered in the ultrasonic range to prevent interference, e.g. from camera autofocus

A complete Colette-series microphone consists of an MK capsule and a CMC amplifer. All capsules and active accessories of the Colette system are compatible with the CMC 1. The CMC 1 works with standard 12-Volt or 48-Volt phantom powering. Power consumption is lower at 12 Volts, an advantage for battery-powered operation.

CMC 1 U FEATURES:

  • complete alternative to the renowned CMC 6
  • fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes
  • suitable mounting accessories are already available, such as the CINELA E-OSIX-CMC1U and the Rycote INV-6 elastic suspensions.

SCHOEPS MK 5:

With the Schoeps MK 5, pattern switching is purely mechanical via a sliding lever on the side of the capsule. The result in each setting is like an independent microphone capsule with the same quality as the MK 2S / MK 4, and very similar (though not identical) frequency and polar response characteristics. In contrast to most dual-diaphragm microphones, the cardioid setting of the MK 5 maintains its directivity even at the lowest frequencies, and has high frequency response up to 20 kHz. In addition, the MK 5 has excellent low-frequency response in the omnidirectional setting along with the low sensitivity toward wind, vocal "popping" noise and solid-borne sound typical of pressure transducers.

MK 5 FEATURES:

  • mechanical switching between omnidirectional and cardioid patterns
  • true one-diaphragm system (unique on the microphone market)
  • pure pressure transducer in the omni setting, pressure gradient transducer in the cardioid setting
  • can be used in nearly any situation, often suggested as an initial acquisition. Popular with training institutes

CMC 1 U SPECIFICATIONS:

  • frequency range: 20 Hz-20 kHz
  • maximum output voltage: 1,8 V (5 dbV) with 1 kOhm load
  • maximum sound pressure level (THD < 0.5 %): 135 dB-SPL (P48) with MK 4, 131 dB-SPL (P12) with MK 4
  • low cut filter: 20 Hz, 12 dB/oct
  • output impedance: 50 Ohm approx. 1 Ohm (8 Hz 50 kHz)
  • minimum recommended load impedance: 1 kOhm
  • common mode rejection ratio (at 1 kHz): > 55 dB
  • maximum cable length: > 400 m
  • Schoeps RFI shield: yes
  • powering standard / valid range: P48 / 30-52 V, P12 / 11-13 V
  • current consumption: 2 mA (P48), 3 mA (P12)
  • output: XLR-3M, analog, 1 channel
  • length: 39 mm
  • diameter: 20 mm
  • weight: 36 g
  • surface finish: matte grey (g) or custom color

MK 5 SPECIFICATIONS:

MK 5 - OMNI:

  • frequency range: 20Hz to 20kHz
  • sensitivity: 10mV/Pa
  • equivalent noise level (A-weighted): 14dB-A
  • equivalent noise level (CCIR): 26dB
  • signal-to-noise ratio (A-weighted): 80dB-A
  • maximum sound pressure level at 0.5% THD: 133dB-SPL

MK 5 - CARDIOID:

  • frequency range: 40Hz to 20kHz
  • sensitivity: 13mV/Pa
  • equivalent noise level (A-weighted): 15dB-A
  • equivalent noise level (CCIR): 24dB
  • signal-to-noise ratio (A-weighted): 79dB-A
  • maximum sound pressure level at 0.5% THD: 132dB-SPL

MECHANICAL SPECIFICATIONS:

  • length: 27 mm
  • diameter: 20 mm
  • weight: 25 g

More Information
BrandSchoeps
THERE ARE 2 OPTIONS AVAILABLE:
1. Pick-up your order at our store.
2. Choose one of the different options from our shipping partners, presented to you during check-out.