DPA 4011ES
d:dicate 4011E cardioid microphone, active side-exit cable.
- Ultra-compact spot or hanging mic
- Very linear frequency and phase response
- Huge dynamic range
- Low-key appearance
Ideal for unobtrusive spot miking, such as hanging or table use, the 4011E is an ultra-compact cardioid microphone from the modular DPA d:dicate recording microphones series.
With a length of only 3.5cm, the low-key appearance of the 4011E is followed by the SM4000-C suspension mount, which is included in the package. This allows the 4011E to be hung from the ceiling and create precise and repeatable positions and angles when spot miking orchestra sections or ambience atmospheres.
Capable of handling high SPLs without distortion, the 4011E is perfectly tailored for close-miking applications, minimizing bleed from other instruments. Therefore chosen for close-miking of instruments like acoustic guitar, drums or grand piano, the 4011E with its accessories can be placed for instance in the piano frame.
At any time and with no tools necessary it is possible to transform the basic 4011E microphone into a new configuration by combining it with another DPA microphone capsule or preamp.
- Directional pattern: cardioid
- Principle of operation: pressure gradient
- Cartridge type: pre-polarized condenser
- Frequency range: 20Hz to 20kHz
- Frequency range, +/-2dB: 40Hz to 20kHz
- Sensitivity, nominal, +/-2dB at 1kHz: 10mV/Pa, -40dB re. 1V/Pa
- Equivalent noise level, A-weighted: typ. 18dB(A) re. 20uPa (max. 20dB(A))
- Equivalent noise level, ITU-R BS.468-4: typ. 25dB
- S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 76dB(A)
- Total harmonic distortion (THD): <1% up to 139dB SPL peak
- Dynamic range: typ. 121dB
- Max. SPL, peak before clipping: 144dB
- Output impedance: 100Ohm
- Minimum load impedance: 2kOhm
- Cable drive capability: 100m
- Output balance principle: Impedance balancing
- Common mode rejection ratio (CMRR): >40dB
- Power supply (for full performance): 48V Phantom power (+/-4V)
- Current consumption: 3.5mA
- Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
- Color: matte black
- Weight: 109g
- Microphone/capsule diameter: 19/19mm
- Microphone length: 35mm
- Maximum output voltage, RMS: 2.2V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40°C to 45°C
- Relative humidity (RH): up to 90%
- Matching tolerance (frequency response and sensitivity): +/-1dB
- Phase deviation for kit: <10°
| Brand | DPA |
|---|
