DPA 3532-SP
The 3532-SP is a complete state-of-the-art A-B stereo kit with two 4041-SP microphones, carefully matched within +/-0.5dB on both frequency response and sensitivity in the microphone's entire frequency bandwidth.
It is the ultimate choice for the demanding engineer and audio purist who emphasizes clarity, openness, precision, low self-noise and high sensitivity.
The kit is designed for a broad range of uses, mainly as main pair for classical, jazz and folk genres, grand pianos, guitars, overheads or close-miking drums, choirs, strings, wind instruments and much more. You get a bright and transparent sound quality with lots of headroom. With its soft boost, which is present on-axis, and gradually goes towards linearity off-axis, the 4041-SP omni microphone can be angled to use as a natural equalizer.
What's in the box
- 2x 4041-SP large diaphragm microphone, P48, factory-matched
- 2x DUA0021 foam windscreeen
- 1x UA0836 stereo boom with holders
- 1x DYS0917 thread adapter for stereo boom
- 2x UA0961 microphone holder
- Directional pattern: omnidirectional
- Principle of operation: pressure
- Cartridge type: condenser w. stainless steel diaphragm
- Frequency range: 20Hz to 20kHz
- Frequency range, +/-2dB: 20Hz to 20kHz with 4 to 6dB soft boost at 8kHz
- Sensitivity, nominal, +/-2dB at 1kHz: 70mV/Pa, -23dB re. 1V/Pa
- Equivalent noise level, A-weighted: max. 8dB(A) re. 20uPa
- Equivalent noise level, ITU-R BS.468-4: max. 20dB
- S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 86dB(A)
- Total harmonic distortion (THD): <0.5% up to 120dB SPL peak, <1% up to 126dB SPL peak
- Dynamic range: typ. 118dB
- Max. SPL, peak before clipping: 134dB
- Output impedance: <200Ohm
- Cable drive capability: 100m
- Power supply (for full performance): via external power supply
- Current consumption: 2.20mA
- Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
- Weight: 190g
- Capsule diameter: 24mm
- Microphone length: 170mm
- Temperature range: -40°C to 45°C
- Relative humidity (RH): up to 90%
- Matching tolerance (frequency response and sensitivity): +/-0.5dB
- Phase deviation for kit: <5°
| Brand | DPA |
|---|
