DPA 2011ER
d:dicate 2011E twin diaphragm cardioid microphone, active rear-exit cable.
- Blends clarity, richness and dynamics
- Twin-Diaphragm capsule and interference tube technologies
- Superb isolation and level control for hanging or table use
- Modular flexibility
2011E is part of the flexible DPA d:dicate recording microphones series. The 2011E with the MMP-E active cable offers an ultra-compact appearance with excellent directivity control and radio frequency interference rejection. 2011E is ideal for over-stage hanging or table applications and the construction combines the twin diaphragm capsule and DPA's strong know-how within interference tube technology. While the DPA 4011 cardioid has gained worldwide admiration for its total linearity at all sound confrontations, the 2011 is purposely designed differently, the off-axis response is still linear but in a smaller frequency bandwidth making stage separation and gain-to-feedback higher and mic level easier to control. At any time and with no tools necessary it is possible to transform the basic 2011 microphone into a new configuration by combining it with another DPA microphone capsule or preamp.
Twin diaphragm capsule: cutting edge technology. The overall distinctive sound image from the DPA miniatures is so well balanced that it meets the high demands of the d:dicate recording microphone range. In a 2011 capsule two opposite facing miniature capsules are custom re-built into a double diaphragm, one-capsule composition. The use and control of interference tubes has become a DPA specialty and the 2011 is no exception, the capsules are loaded to the supreme d:dicate preamps instead of the tiny miniature FET preamp from the 4060 miniature series, offering even more air and precision.
Stage addict: the 2011E has found its use on numerous stages and studios requiring visual elegance. Exhibiting a previously unheard blend of clarity, richness and dynamic range, the 2011 performs like a much more exclusive microphone and redefines the term value for money.
- Directional pattern: cardioid
- Principle of operation: pressure gradient
- Cartridge type: pre-polarized condenser
- Frequency range: 20Hz to 20kHz
- Frequency range, +/-2dB @ 30cm: 40Hz to 20kHz
- Sensitivity, nominal, +/-2dB at 1kHz: 10mV/Pa, -40dB re. 1V/Pa
- Equivalent noise level, A-weighted: typ. 18dB(A) re. 20uPa (max. 20dB(A))
- Equivalent noise level, ITU-R BS.468-4: typ. 25dB
- S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 76dB(A)
- Total harmonic distortion (THD): <1% up to 139dB SPL peak
- Dynamic range: typ. 121dB
- Max. SPL, peak before clipping: 144dB
- Output impedance: 100Ohm
- Minimum load impedance: 2kOhm
- Cable drive capability: 100m
- Output balance principle: Impedance balancing
- Common mode rejection ratio (CMRR): >40dB
- Power supply (for full performance): 48V Phantom power (+/-4V)
- Current consumption: 3.5mA
- Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
- Color: matte black
- Weight: 109g
- Microphone/capsule diameter: 19mm
- Microphone length: 35mm
- Maximum output voltage, RMS: 2.2V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40°C to 45°C
- Relative humidity (RH): up to 90%
- Matching tolerance (frequency response and sensitivity): +/-1dB
- Phase deviation for kit: < 10°
Brand | DPA |
---|