DPA 2011A
d:dicate 2011A twin diaphragm cardioid microphone.
- All-round workhorse blends clarity, richness and dynamics
- Twin-Diaphragm-Capsule and interference tube technologies
- Superb stage separation and level control
- Modular flexibility
All-round workhorse: the new DPA 2011A microphone has strong references to the acclaimed close-miking and hi-SPL handling specialist DPA 4011 cardioid microphone - not only by its type number 11, also in its all-round capture abilities. 2011 is primarily optimized for on-stage use and the technology combines the new twin diaphragm capsule and DPA's strong know-how within interference tube technology. While 4011 has gained worldwide admiration for its total linearity at all sound confrontations, the 2011 is purposely aimed differently, the off-axis response is still linear but in a smaller frequency bandwidth making stage separation and gain-to-feedback higher and mic level easier to control.
Modular flexibility: the 2011A is part of the flexible DPA d:dicate recording mics series. The 2011A with the MMP-A preamplifier is the audiophile's choice with low distortion and total accurate and faithful sound, where the 2011C with the MMP-C compact preamplifier offers a subtle character alteration with a bit more "body" to the low end - in addition to its easier-to-position approach. At any time and with no tools necessary it is possible to transform the basic 2011 microphone into a new configuration by combining it with another DPA microphone capsule or preamp.
Twin diaphragm capsule: cutting edge technology. The overall distinctive sound image from the DPA miniatures is so well balanced that it meets the high demands of the DPA d:dicate recording microphone range. In a 2011 capsule two opposite facing miniature capsules are custom re-built into a double diaphragm, one-capsule composition. The use and control of interference tubes has become a DPA specialty and the 2011 is no exception, the capsules are loaded to the supreme d:dicate preamps instead of the tiny miniature FET preamp from the 4060 miniature series, offering even more air and precision.
Stage addict: the 2011 has found its use on numerous stages and recording sessions. Exhibiting a previously unheard blend of clarity, richness and dynamic range, the 2011 performs like a much more exclusive microphone and redefines the term value for money.
- Directional pattern: cardioid
- Principle of operation: pressure gradient, with interference tube
- Cartridge type: pre-polarized condenser, Twin-Diaphragm-Capsule
- Frequency range: 20Hz to 20kHz
- Frequency range, +/-2dB @ 30cm: 50Hz to 17kHz with 3dB soft boost at 12kHz
- Sensitivity, nominal, +/-2dB at 1kHz: 10mV/Pa, -40dB re. 1V/Pa
- Equivalent noise level, A-weighted: typ. 20dB(A) re. 20uPa (max. 23dB(A))
- Equivalent noise level, ITU-R BS.468-4: typ. 33dB (max. 36dB)
- S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 74dB(A)
- Total harmonic distortion (THD): <1% up to 137dB SPL peak
- Dynamic range: typ. 117dB
- Max. SPL, peak before clipping: 153dB
- Switchable attenuator, filters etc.: 0dB / -20dB
- Output impedance: 200Ohm
- Minimum load impedance: 2kOhm
- Cable drive capability: 100m
- Output balance principle: Impedance balancing with "Active Drive"
- Common mode rejection ratio (CMRR): >60dB
- Power supply (for full performance): 48V Phantom power (+/-4V)
- Current consumption: 2.8mA
- Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
- Color: matte black
- Weight: 160g
- Microphone diameter: 19mm
- Microphone length: 198mm
- Maximum output voltage, RMS: 5V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40°C to 45°C
- Relative humidity (RH): up to 90%
Brand | DPA |
---|